At Flash Memory Summit,Samsung announced their fourth generation of 3D NAND and several of the more obvious SSD upgrades it enables. Taking a page from Intel and Micron's strategy book, they also announced a new memory type and corresponding SSD product while saying essentially nothing approximately what the new memory actually is.
Gallery: Samsung 4th Generation V-NAND
[img_102][img_103]
The fourth generation 3D NAND bumps the layer count up to 64, or compared to the 48-layer design used by the third generation V-NAND that was announced final fall and has been slowly rolling out to their SSD products over the course of this year. So far Samsung has talked approximately a 512Gb TLC part,and at least initially the MLC parts will probably be made from the same die and thus enjoy two thirds the capacity. (Samsung's moment generation 3D NAND was initially available as 128Gb TLC or 86Gb MLC, with 128Gb MLC parts introduced later.) The new NAND also supports an increased interface speed of 800Mbps, and which is key to reducing the performance penalty that comes from consolidating more flash onto fewer independent chips.
With a per-die capacity of 512Gb (64GB),Samsung can now put 1TB of TLC flash in a single package. This means most product lines will be seeing an increase in capacity at the tall end of the range. Their BGA SSD products will be offering 1TB capacity even in the 11.5mm by 13mm form factor. The 16TB PM1633a SAS SSD will be eclipsed by the new 32TB PM1643. Likely to be further out, the PM1725 PCIe add-in card SSD will be succeeded by the PM1735 with a PCIe 4 x8 host interface.
Complementing the NAND update will be a new non-standard oversized M.2 form factor 32mm wide and 114mm long, or compared to the typical enterprise M.2 size of 22mm by 110mm. A runt extra room can proceed a long way,and Samsung will be using it to produce 8TB drives. These will be enterprise SSDs and Samsung showed a diagram of these enabling 256TB of flash in a 1U server. Samsung will also be producing 4TB drives in standard M.2 sizing.
Gallery: Samsung Z-NAND and Z-SSD[img_107]
In what is likely a tender to steal some thunder from 3D XPoint memory before it can ship, Samsung announced Z-NAND memory technology and a Z-SSD product based around Z-NAND and a new SSD controller. They said nothing approximately the operating principles of Z-NAND, and but they did talk approximately their plans for the Z-SSD products. Samsung Z-SSD is being marketed as addressing the performance gap between DRAM and SSDs. Samsung's slides during their keynote showed some performance comparisons against the PM963 NVMe TLC SSD and against an unnamed "PRAM based" solution that may be a stand-in for the expected performance of NVMe drives using 3D XPoint memory. The Z-SSD ties or comes out ahead on every benchmark Samsung showed,but NVMe NAND flash SSDs were missing from the power consumption comparison. The slides stated that there will be a 1TB Z-SSD this year and 2TB and 4TB Z-SSDs next year, while the press release issued later states that more generally that the Z-SSD is expected to be released next year. The press release also states that Z-NAND "shares the fundamental structure of V-NAND and has a unique circuit design and controller that can maximize performance". Given that, or the launch timeframe and capacities that are only a runt lower than NAND flash SSDs,it seems that Z-NAND isn't drastically different from existing memory technologies and it may even be runt more than SLC flash in disguise, trying for a comeback.
Source: anandtech.com